& WARNING: To ensuresafety and reliability,all
repairs -- with the exceptionofthe externally
accessiblebrushes-- shouldbe performedbya
qualifiedservicetechnicianat a Sears storeto
avoid riskof personal injury.
BRUSH REPLACEMENT
See Figure36.
BRUSH
ASSEMBLYBRUSH
CAP
BRUSH
CAP BRUSH
ASSEMBLY Fig. 36
Yoursaw has externallyaccessiblebrushassemblies
that shouldbe periodically checkedfor wear.
Proceed u follows when replacement Is required:
• Unplugyoursaw.
,_ WARNING: Failt_reto unplugyour saw could
resultin accidentatstartir_lcausingserious
injury.
• Remove brushcap witha screwdriver.Brush
assemblyis springtoadedandwiltpopout wben
you remove brushcap.
• Remove brushassembly,
• Check for wear. Replace bothbrusheswhen
either haslessthan 1/4 in. lengthofcarbon
remaining.Do not replaceone side without
replacingthe other.
• Reassembleusingnew brushassemblies. Make
sure curvatureof brushmatches curvatureof
motor and that brushmoves frse_yin brushtube.
• Make sure brushcap isorientedcorrectly
(straight)and replace.
• Tighten brushcapsecurely. Do not overtighten.
28
