A SERVICE OF

logo

Open as PDF
next previous
6
Call1-866-576-8388formissingpartsorassemblyhelp
DONOTRETURNTOSTORE
FIGURE 2
LIFT LEVER
ASSEMBLY
SLEEVE HITCH
FRAME ASSEMBLY
WELD
PIN
5/8" NYLOCK NUT
SPACER PLATE
(SEE NOTE)
HEX BOLT
5/8" x 1-3/4"
STEP 1: (SEE FIGURE 2)
• HooktheSleeveHitchFrameassemblyontotheweld
pins.Attachthebottomoftheassemblytothetractor
hitchusinga5/8"x1-3/4"hexboltanda5/8"nylock
nut.
NOTE:Ifyourtractorhitchhasridgesthatpreventthe
sleevehitchassemblyfromrestingat,placethespacer
plateunderneaththesleevehitchassembly.
STEP 2: (SEE FIGURE 2)
• ProceedtoLIFTASSEMBLYinstructionsonpage8.
MOUNTING BRACKET ASSEMBLY
FIGURE 1A
3/8" HEX NUT
3/8" LOCK WASHER
LEFT MOUNTING BRACKET
3/8" x 1-1/4"
HEX BOLT
RIGHT MOUNTING BRACKET
IF YOUR TRACTOR LOOKS LIKE FIGURE 1A
• Installtwo3/8"x1-1/4"hexboltsintheleftsideofthe
tractor as shown. Attach the Left Mounting Bracket
(pinattopfacingin)totheboltsusingtwo3/8"lock
washersand3/8"hexnuts.Repeatontherightside.
FIGURE 1B
ORIGINAL NUT
LEFT MOUNTING
BRACKET
3/8" FLAT WASHER
(TOP HOLE ONLY)
REMOVE NUTS
FROM BOLTS
RIGHT MOUNTING
BRACKET
3/8" LOCK WASHER
(If new bolt and nut are needed)
IF YOUR TRACTOR LOOKS LIKE FIGURE 1B
• Removethenutsfromthetwoboltsshownineach
sideofthetractor,leavingtheboltsinplace.
• AttachtheLeftMountingBracket(pinattopfacing
in)totheboltsusingtheoriginalnutsanda3/8"at
washer.Repeatfortheotherside.
NOTE:Ifnoboltandnutarepresentinahole,usea
3/8"x1-1/4"hexbolt,3/8"lockwasherand3/8"hexnutto
attachtheMountingBrackettothehole.
THIS ASSEMBLY IS FOR 917 TRACTOR MODELS ONLY.