CyberData Corporation 930181B Operations Guide
Installing the VoIP Intercom
Intercom Setup
14
2.2.6.2 Restoring the Factory Default Settings
To restore the factory default settings:
1. Complete the steps in Section 2.2.6.1, "Announcing the IP Address".
2. Press and hold the Call bu
tton for 10 seconds.
3. When you hear the announcement, release the Ca
ll button. The factory default settings are
restored, and the intercom will automatically restart.
2.2.6.3 Restore the Factory Default Settings
When troubleshooting configuration problems, it is sometimes convenient to restore the device to a
known state.
Each Intercom is delivered with factory set def
ault values for the parameters indicated in Table 2-3.
Use the RT
FM switch on the Intercom face to restore these parameters to the factory default settings.
Note Whe
n you use the RTFM switch, the factory default settings are restored for only the
parameters indicated in Table 2-3. The other parameters in the current Intercom
configuration will remain unchanged.
To restore these parameters to the factory default settings:
Table 2-3. Factory Default Settings
Parameter Factory Default Setting
IP Addressing static
IP Address 192.168.3.10
Web Access Username admin
Web Access Password admin
Subnet Mask 255.255.255.0
