A SERVICE OF

logo

Open as PDF
next previous
l EN 61000-3-2 — "Electromagnetic Compatibility (EMC) - Part 3: Limits - Section2:LimitsforHarmonicCurrentEmissions(EquipmentInputCurrentUpto
and Including 16 A Per Phase)."
l EN 61000-3-3 — "Electromagnetic Compatibility (EMC) - Part3:Limits-Section3:LimitationofVoltageFluctuationsandFlickerinLow-Voltage Supply
SystemsforEquipmentWithRatedCurrentUptoandIncluding16A."
l EN 60950-1 — "Safety of Information Technology Equipment."
l EN 60825-1 — "Safety of Laser Products."
l Class A is for typical commercial areas.
l Class B is for typical domestic areas.
This Dell device is classified for use in a typical Class B domestic environment.
A "Declaration of Conformity" in accordance with the preceding directives and standards has been made and is on file at Dell Inc. Products Europe BV, Limerick,
Ireland.
EN 55022 Compliance (Czech Republic Only)
Polish Center For Testing And Certification Notice
The equipment should draw power from a socket with an attached protection circuit (a 3-
prong socket). All equipment that works together (computer, monitor,
printer, and so on) should have the same power supply source.
The phasing conductor of the room's electrical installation should have a reserve short-circuit protection device in the form of a fuse with a nominal value no
larger than 16 amperes (A).
To completely switch off the equipment, the power supply cable must be removed from the power supply socket, which should be located near the equipment
and easily accessible.
A protection mark "B" confirms that the equipment is in compliance with the protection usage requirements of standard PN-EN 55022.
NOTE: EN 55022 emissions requirements provide for two classifications: