NOTE: Changing the IP address of the DRAC causes the DRAC to reset. If SNMP polls the DRAC
before it initializes, a temperature warning is logged because the correct temperature is not
transmitted until the DRAC is initialized.
• NIC Selection
NOTE: NIC Selection cannot be configured on modular systems
• Primary and Failover Network options
The Primary Network options for Remote Management (iDRAC7) NIC are: LOM1, LOM2, LOM3,
LOM4, and Dedicated. The Failover Network options are: LOM1, LOM2, LOM3, LOM4, All LOMs, and
None.
NOTE: The number of LOMs varies based on the system or hardware configuration.
• Enable IPMI Over LAN
• IP Address Source
• IP Address
• Subnet Mask
• Gateway Address
• Channel Privilege Level Limit
5. Configure the following optional VLAN configuration details:
NOTE: VLAN configuration is not applicable for systems with iDRAC.
• Enable VLAN ID
• VLAN ID
• Priority
6. Configure the following IPv4 Properties:
• IP Address Source
• IP Address
• Subnet Mask
• Gateway Address
7. Configure the following IPv6 Properties:
• IP Address Source
• IP Address
• Prefix Length
• Default Gateway
• DNS Address Source
• Preferred DNS Server
• Alternate DNS Server
NOTE: You can configure the IPv4 and IPv6 address details only if you enable the IPv4 and IPv6
properties under Additional Configuration.
8. Click Apply Changes.
60
