Convention IDSDM indicator code Description
E Not lit Indicates that the card is missing or is booting
Next steps
Follow the procedure listed in After working inside your system.
Installing the internal dual SD module
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
Steps
1. Locate the IDSDM connector on the system board. To locate the IDSDM connector, see System
board connectors.
2. Align the connectors on the system board and the dual SD module.
3. Push the dual SD module until it is firmly seated on the system board.
Next steps
1. Install the SD vFlash media card(s).
NOTE: Temporarily label each SD card with its corresponding slot before removal. Replace the
SD card(s) into the same slots.
2. Follow the procedure listed in After working inside your system.
Integrated storage controller card
Your system includes a dedicated expansion-card slot on the system board for an integrated controller
card. The integrated storage controller card provides the integrated storage subsystem for your system’s
internal hard drives. The controller supports SAS and SATA hard drives and also enables you to set up the
hard drives in RAID configurations as supported by the version of the storage controller included with
your system.
Removing the integrated storage controller card
Prerequisites
1. Ensure that you read the Safety instructions.
2. Follow the procedure listed in Before working inside your system.
3. Remove the cooling shroud.
4. Keep the #2 Phillips screwdriver handy.
90
