Dell N3010 Manual

next previous

Back to Contents Page

 Processor Heat Sink Fan

Dell™Inspiron™N3010ServiceManual

Removing the Processor Heat Sink Fan

Replacing the Processor Heat Sink Fan



Removing the Processor Heat Sink Fan



1. Follow the instructions in Before You Begin.



2. Remove the battery (see Removing the Battery).



3. Remove the memory-module cover (see Removing the Memory-Module Cover).



4. Remove the memory module(s) (see Removing the Memory Module(s)).



5. Remove the keyboard (see Removing the Keyboard).



6. Remove the palm rest assembly (see Removing the Palm Rest Assembly).



7. Lift the connector latch and pull the pull-tab to disconnect the VGA connector cable from the connector on the system board.



8. Disconnect the processor heat sink fan cable from the connector on the system board.



9. Remove the screw that secures the processor heat sink fan to the computer base.



10. Lift the processor heat sink fan off the computer base.

Replacing the Processor Heat Sink Fan

WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best

practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.

WARNING: If you remove the processor heat sink from the computer when the heat sink is hot, do not touch the metal housing of the heat sink.

CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal

surface (such as a connector on your computer).

CAUTION: Onlyacertifiedservicetechnicianshouldperformrepairsonyourcomputer.DamageduetoservicingthatisnotauthorizedbyDell™

is not covered by your warranty.

CAUTION: To help prevent damage to the system board, remove the main battery (see Removing the Battery) before working inside the

computer.

screw

processor heat sink fan

processor heat sink fan cable

VGA connector cable