A SERVICE OF

logo

a. keyboard
b. memory module
c. hard drive
d. WLAN card
e. access panel
f. optical disk-drive
g. battery
6. Follow the procedures in After Working Inside Your computer.
Removing the Battery Connector
1. Follow the procedures in Before Working Inside Your Computer.
2. Remove:
a. Battery
b. optical disk-drive
c. access panel
d. hard drive
e. memory module
f. keyboard
g. palmrest assembly
3. Perform the following steps as shown in the illustration:
a. Remove the screws that secure the battery connector to the computer [1].
b. Lift the battery connector partially to a 45-degree angle [2].
c. Remove the battery connector from the computer [3].
Installing the Battery Connector
1. Tighten the screws to secure the battery connector to the computer.
2. Install the:
a. palmrest assembly
20