Page 19
Section 6 ... S 2000T Character Sets
Resident Character Sets
§ The Series 2000T has two resident character sets, the standard international and IBM
compatible character sets. For both resident character sets, the lower 128 bit values follow
the ASCII standard. Characters 0 through 31 are reserved ASCII printer control
characters, while 32 through 127, are the ASCII alpha numeric upper lower case
characters. The extended characters are from 128 to 255.
§ For the international character set, the upper 128 bit values code a collection of characters
and symbols.
§ The IBM compatible character set, the upper 128 bit values code a collection of block
graphic characters and special characters for drawing frames and boxes.
§ The printer defaults to the international character set on initial power up. To select an
alternate character set the following command strings are recognized.
CHARACTER NAME MSP FONT COURIER FONT
International character set ESC+F+1 ESC+6
IBM compatible character set ESC+F+2 ESC+7
Resident Fonts
§ The S2000T printer has two built-in user selectable fonts. MSP Dot-matrix and Courier
type fonts. For each font type, several font typefaces are available, this feature enables 24
through 64 column printing.
§ Listed below are the fonts installed, properties and typeface command strings to select
them.
FONT NAME
PITCH COLUMNS PER
LINE
CHARACTER
SIZE (WxH)
SOFTWARE
COMMAND
MSP
ESC+F+1 or
ESC+F+2
32 cpi 64 6x16 ESC+F+9
24 cpi
48 8x16
ESC+F+8
21 cpi
42 10x16
ESC+F+7
20 cpi
40 10x16
ESC+F+6
16 cpi
32 12x16
ESC+F+5
12 cpi
24 16x16
ESC+F+4
COURIER
ESC+F+6 or
