P/2 DA8 and P/2 DA12 • Installation and Operation
2-7
Rear Panel Features
All power, input and output connections are located on the rear
panels of all models, as shown in the figure below.
L2R
L1R
L4R
L3R
L6R
L5R
L8R
L7R
2468
1A357
8
7
6
5
4
3
2
INPUT
VIDEO OUTPUTS
AUDIO OUTPUTS
MUTE
1
50/60 Hz
100-240V 0.3A
L2
12
R
L1R
L4R
L3R
L6R
L5R
L8R
L7R
L10R
L9R
L12
24681012
1A357911
R
L11R
11
10
9
8
7
6
5
4
3
2
INPUT
VIDEO OUTPUTS
AUDIO OUTPUTS
MUTE
1
50/60 Hz
100-240V 0.3A
3 875
6
4
2468
1A357
8
7
6
5
4
3
2
INPUT
VIDEO OUTPUTS
MUTE
1
50/60 Hz
100-240V 0.3A
12
24681012
1A357911
11
10
9
8
7
6
5
4
3
2
INPUT
VIDEO OUTPUTS
MUTE
1
50/60 Hz
100-240V 0.3A
P/2 DA8
P/2 DA12
P/2 DA8 A
P/2 DA12 A
Figure 2-4 — Rear panel features
c
AC power connection — Use the provided IEC connector to
connect the unit to a convenient power socket. The internal
power supply will support 100-240 VAC, 50-60 Hz.
d
Video input — One female DB-15 connector is used for video
input. Acceptable input formats include: RGBHV, RGBS,
RGsB, RsGsBs, YUV (tri-level and bi-level sync), S-video, and
composite video. (See page 2-9.)
e
Audio input (P/2 DA8 A and P/2 DA12 A models only) — One
female 3.5 mm TRS connector accepts unbalanced audio input.
(See page 2-10.)
f
Video outputs — Up to eight (P/2 DA8 series) or twelve (P/2
DA12 series) outputs can be connected using female DB-15
connectors. The output signal format follows that of the input.
(See page 2-9.)
N
ID bits on pins 4, 11, 12, and 15 are routed to Output 1.
g
Audio outputs (P/2 DA8 A and P/2 DA12 A models only)
— Up to eight (P/2 DA8 A) or twelve (P/2 DA12 A) outputs
can be connected using 3.5 mm 5 pole captive screw connectors.
Outputs can be balanced or unbalanced. (See page 2-10.)
h
Mute controls — On P/2 DA 8 models, two 3.5 mm, 5-pole
captive screw connectors will be used to mute video and audio
from specific or all outputs. On P/2 DA12 models, two 3.5 mm,
4 pole and two 3.5 mm, 3 pole captive screw connectors will be
used. (See page 2-11.)
