A SERVICE OF

logo

Open as PDF
next previous
7. Insert the captive screw connector into the four-pole receptacle on the speaker
crossover board as shown below.
Zip Tie
Captive Screw
Connector
Strain Relief
Tie off Point
Figure 3. Strain Relief Tie Off Point
8. Secure the speaker wire to the strain relief tie off point using the included zip tie as
shown above.
9. Mount the SF 26X.
a. Insert the SF 26X through the bottom of the hole in the ceiling tile that was cut in
step 2.
b. Tighten the four screws (clockwise) of the locking arms until the arms are fully
engaged and the speaker is securely clamped to the ceiling, as shown below.
ATTENTION: Do not overtighten the screws.
Speaker Grille
Locking Arm
Figure 4. Mounting the Speaker Using the Four Locking Arms
SF 26X User Guide • Installation 9