209
CHAPTER 10 UART
10.4.3 Serial Status and Data Register (SSD)
The serial status and data register (SSD) is used to set and monitor transmit/receive
operation and error status.
■ Serial status and rate register (SSD)
Figure 10.4-4 Serial status and data register (SSD)
Address Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0 Initial value
0022
H
RDRF ORFE TDRE TIE RIE TD8/TP RD8/RP 00100-1X
B
R R R R/W R/W R/W R
RD8/RP Received data parity selection bit
Transmitted data parity selection bit
Receiver interrupt enable bit
Transmitter interrupt enable bit
Transmission data register empty bit
Receive data flag bit/Error flag bit
0 Odd parity
1
Even parity
TD8/TP
0
Odd parity
1
Even parity
RIE
0 Disables interrupt
1 Enables interrupt
Enables interrupt
TIE
0 Disables interrupt
1
TDRE
0
Full of transmission data
1 Empty
RDRF ORFE
0 0 No data
01
Framing error
(When new data is received at
this state, RDRF will not be set)
1 0 Normal data
11
Overrun error (Previous data
remains)
R
: Read-only
: Unused
X
: Indeterminate
—
: Initial value
R/W
: Readable and writable
