1. OPERATION
1-32
Offset
If there is a difference between sensor bearing and actual bearing, enter it as
below. For example, if the sensor shows 70° and the actual bearing is 75°, enter
+5(°).
10. Choose OFFSET and press the [ENT] key.
11. Use ▲ or ▼ to choose minus or plus respectively, whichever is appropriate.
12. Press ► to shift the cursor one place.
13. Use ▲ or ▼ to enter appropriate value.
14. Press ► to shift the cursor one place.
15. Use ▲ or ▼ to enter appropriate value.
16. Press the [ENT] key.
17. Press the [MENU] key twice to finish, or go to step 15 to enter damping factor
(C-2000).
Damping (C-2000)
Damping determines how sensitively the sensor responds to change of ship’s
heading. Use a small value for faster response.”1” is the default setting. Note
that damping value must be received from the C-2000 to display the item
DAMPING on the HDG SETUP menu.
18. Choose DAMPING and press the [ENT] key.
0
1
2
3
Damping options
19. Choose damping value. The larger the number the slower the response.
20. Press the [ENT] key.
21. Press the [MENU] key twice to close the menu.
