information regarding these features.
*Refer to the Power Supply and Wiring Instructions sections of this manual for further
switch position.
(bypassing the power switch) and the green LED light is lit regardless of
•
off to regulate power through the unit.
By-Pass Installation - In this set-up, the unit is continuously powered
•
This docking station has a power switch with an LED light (see Figure 1):
Figure 1
docking station and bypass the power switch.
Standard Installation - In this set-up, the power switch can be turned on and
•
switch on the docking station, regulating power through the unit.
By-Pass Installation - Use the BLUE and BLACK wires to continuously power the
•
Power is provided using the wires located on the underside of the docking station:
volt DC system. The voltage output is factory set at 19 volts.
This docking station has a built-in power supply and is designed to be used with an 11 - 28
POWER SUPPLY INFORMATION
Page 4 of 8
POWER SWITCH
Standard Installation - Use the RED and BLACK wires to utilize the power
Power Switch w/
Green "POWER" LED
Red, Black &
Blue Wires w/
Disconnect
"INPUT POWER" - The green LED light, built into the power switch, indicates that there is •
power to the unit.
