9
Fitting and removing the battery pack
To remove the battery pack from the blower firmly press
the battery release tabs (4) at either side of the battery
pack, and slide the battery backward out of the tool.
To install the battery pack,
align rails, on the tool with the
tabs on the battery pack and
slide the battery pack on to
the blower. Ensure the battery
pack is sitting straight on the
foot and correctly entering the
runners. The battery should
slide fully on to the drill foot
until the battery pack “clicks”
into position.
Battery charging
1. Connect charger (5) to
power source. The green light
(a), should light up. This
indicates the charger is ready
to begin charging.
2. Position battery pack on
charger, align rails (d), on
battery charger with (e) on
battery pack. Slide battery
forward onto charger until it
clicks into position.
3. The red light (b), should
begin to glow continuously,
indicating that the battery
pack is receiving a “Fast
Charge”.
4. After approximately one
hour, the “Fast Charge”
indicator red light (b) should
go out indicating that the
battery pack is fully charged
and that the charger is now
in a “Maintenance Charge”
mode, this is confirmed by the light (a) coming back
on. The battery pack can be left on “Maintenance
Charge” until you are ready to use it, however it is not
recommended to leave the battery on charge for longer
that 24 hours.
5. To remove the battery pack from the charger depress the
battery pack release tabs (4) and slide the battery off.
WARNING. Do not leave batteries charging for longer than
24 hours. Note. Depending on room temperature, line
voltage, and existing charge level, initial battery charging
may take longer than one hour.
NOTE. Disconnect charger from power source when not
in use.
To obtain the best life for the battery
• Never allow the drill to come to a complete stand still
before recharging. The battery should be placed on
charge whenever the battery is noticeably running
down or the drill no longer performs a task it
previously performed.
• Avoid conducting short charges. Make sure that the
battery is fully charged every time by allowing the
charger to complete its full charging cycle.
• Avoid allowing lose items like screws or nails etc to be
stored with battery packs as these or similar items can
short battery packs and cause a fire or explosion.
• Always unplug the charger when not in use and store in
a dry secure place.
• Avoid charging or storing your battery in temperatures
below 0ºC and above 40ºC.
e
b
a
d
