
Directions to configure local TFTP:
1. Unzip the file and put all of them under the root directory of the TFTP server.
2. The PC running the TFTP server and the GXP-2000 should be in the same LAN
segment.
3. Go to File -> Configure -> Security to chang
"Receive Only" to "Transmit Only" for the fir
e the TFTP server's default setting from
mware upgrade.
reboot the unit
Use //httpd.apache.org/
4. Start the TFTP server, in the phone’s web configuration page
5. Configure the Firmware Server Path with the IP address of the PC
6. Update the change and
r can also choose to download the free HTTP server from
http: or use Microsoft IIS
web
phone boots up, it will send TFTP or HTTP request to download configuration
file “cfg000b82xxxxxx”, where “000b82xxxxxx” is the MAC address of the GXP-2000 phone. This
initial provisioning purpose only.
ns (prior to 1.1) when the LCD becomes pale or white a power cycle is
he GXP-2000 can be configured via Web Interface as well as via Configuration File through TFTP or
associated with each particular field in the web configuration page. A
arameter consists of a Capital letter P and 2 to 3 (Could be extended to 4 in the future) digit numeric
nce the GXP-2000 boots up (or re-booted), it will request a configuration file named “cfgxxxxxxxxxxxx”,
the MAC address of the device, i.e., “cfg000b820102ab”. The configuration file
in
minutes, default and minimum is 60 minutes) to have the devices periodically check for upgrades at pre-
server.
NOTE:
• When GXP-2000
file is for
• For normal TFTP or HTTP firmware upgrades, the following error messages in a TFTP or HTTP
server log can be ignored: “TFTP Error from [IP ADRESS] requesting cfg000b82023dd4 : File
does not exist. Configuration File Download”
NOTE: For earlier firmware versio
required. For hardware version 1.1 or later, the phone automatically reboots after the firmware upgrade is
complete.
CONFIGURATION FILE DOWNLOAD
T
HTTP. “Upgrade Server” is the TFTP or HTTP server path for the configuration file. It needs to be set to a
valid URL, either in FQDN or IP address format.
A configuration parameter is
p
numbers. i.e., P2 is associated with “Admin Password” in the ADVANCED SETTINGS page. For a
detailed parameter list, please refer to the corresponding configuration template of the firmware.
O
where “xxxxxxxxxxxx” is
name should be in lower cases.
Managing Firmware and Configuration File Download
When “Automatic Upgrade” is set to “Yes”, a Service Provider can use P193 (Auto Check Interval,
scheduled time intervals. By defining different intervals in P193 for different devices, a Server Provider
can manage and reduce the Firmware or Provisioning Server load at any given time.
Grandstream Networks, Inc. GXP-2000 Users Manual Page 28 of 33
Firmware 1.1.1.14 Last Updated: 12/2006