HandyTone-496 User Manual Grandstream Networks, Inc.
23
Grandstream Device Configuration
STATUS BASIC SETTINGS ADVANCED SETTINGS FXS PORT1 FXS PORT2
Admin Password:
(purposely not displayed for security protection)
Home NPA:
Layer 3 QoS:
48
(Diff-Serv or Precedence value)
Layer 2 QoS:
802.1Q/VLAN Tag
0
802.1p priority value
0
(0-7)
STUN server is :
stun.mycompany.com
(URI or IP:port)
keep-alive interval:
20
(in seconds, default 20 seconds)
Use NAT IP:
(used in SIP/SDP message if specified)
irmware Upgrade and
Provisioning:
Upgrade Via TFTP HTTP
Firmware Server Path:
192.168.1.193
Config Server Path:
192.168.1.193
Firmware File Prefix: Firmware File Postfix:
Config File Prefix: Config File Postfix:
Automatic Upgrade:
No Yes, check for upgrade every
1008
minutes (default 7 days)
Always Check for New Firmware
Check New Firmware only when F/W pre/suffix changes
Firmware Key:
Onhook Threshold:
(in Hexadecimal Representation)
800 ms
XS Impedance:
600 Ohm (North America)
Caller ID Scheme:
Bellcore (North America)
Onhook Voltage:
36V
Polarity Reversal:
No Yes (reverse polarity upon call establishment and termination)
NTP Server:
time.nist.gov
(URI or IP address)
Reply to ICMP on W
N port:
No Yes (Unit will not respond to PING from WAN side if set to No)
