2 Connecting to a Netware 4.11 Server
Windows for Workgroups
2 Connecting to a Netware 4.11 Server
Windows for
Workgroups
Requirements
• HP Vectra VE7/VE8 with DOS and MS-Windows for Workgroups 3.11 in-
stalled.
• 3COM 3C339TokenRing card and drivers disk
DOS ODI - File Name: tlvmp339.dos
DOS and MS-Windows for Workgroups 3.11 media.
• Novell Netware server 3.12 that supports Net BEUI, NWLink IPX/SPX,
and NWLink NetBIOS transfer protocols.
• Netware client for DOS and MS-Windows.
Device Configuration
• I/O Base Address DC00
• Interrupt Request Level 10
• Boot PROM Disabled
• Transceiver Type Auto Select
• Network Driver Optimization Windows or OS/2 Client
• Maximum Modem Speed 9600 Bps
• Full Duplex Disabled
Procedure
1 With the HP Vectra VE7/VE8 set to PNP enabled, turn the machine off
install the 3COM 3C339 adapter card into an PCI slot.
2 Power on the machine and allow it to boot to a DOS prompt.
3 Insert the 3COM drivers diskette and execute 3C339CFG.EXE.
4 Select “CONFIGURE NIC,” and verify the resource settings listed above
under the heading “Device Configuration.”
5 If changes are required, save those changes and exit.
6 Remove the 3COM cards driver diskette and insert Netware client for DOS
and MS-Windows disk 1.
