power-over-ethernet
OVERVIEW
Category:
configPrimary context:
show power-over-ethernet (page 581)Related Commands
Usage: power [slot <SLOT-LIST>] [threshold <1-99>][optional-parameters]
Description: Set Power Over Ethernet(poe) conguration parameters.
threshold - set the power consumption percentage at which
a trap should be sent.
optional-parameters - Use <TAB> or <?> after entering power
to see a list of all available options.
NOTES
Replaces "power" Command
The "interface power-over-ethernet" command replaces the " interface power" command that
was used in earlier versions. The "show power-over-ethernet" command replaces the "show
power-management" command that was used in earlier versions.
COMMAND STRUCTURE
■ [no] power-over-ethernet pre-std-detect -- Detect and power pre-802 (p. 404)
■ [no] power-over-ethernet redundancy -- Set how much power is held in reserve for redundancy
(p. 404)
■ redundancy_type < n+1 | full > -- Set how much power is held in reserve for redundancy
(NUMBER) (p. 404)
■ power-over-ethernet slot -- Optional - Specify a valid powered-slot list for power threshold setting
or omit to set all powered-slots. (SLOT-ID-RANGE) (p. 405)
■ threshold < 1 to 99 > -- Set the power consumption percentage at which a trap should be sent.
(NUMBER) (p. 405)
■ power-over-ethernet threshold < 1 to 99 > -- Set the power consumption percentage at which a
trap should be sent. (NUMBER) (p. 405)
EXAMPLES
Example: interface command with power-over-ethernet
ProCurve(cong)# interface c5-c10, c23-c24, d1-d10, d12 power-over-ethernet high
All ports on module C are prioritized as critical:
ProCurve(cong)# interface c1-c24 power-over-ethernet critical
All ports on module A are prioritized as low:
ProCurve(cong)# interface a1-a24 power-over-ethernet low
403© 2009 Hewlett-Packard Development Company, L.P.
