Saving Configuration Settings and Upgrading Firmware
75hp StorageWorks SAN Switch 2/8 Installation Guide
Restoring the System Configuration Settings
Use these steps to restore the system configuration settings from a backup.
1. Verify that the RSHD service or the FTP service is running on the host
workstation.
2. Log in to the switch as the admin user.
3. Shut down the switch by entering the following command:
switchDisable
4. At the command line enter the following command:
configDownload hostIPaddr, user, path_filename,password
For example, hostIPaddr is the IP address of the host computer, user is
the User ID used to log into this computer, path_filename is the path
location and filename of the system configuration file, and password is the
password for the user ID specified.
Note: The password operand is only required if you are using FTP.
5. Reboot the switch by entering the following command:
fastBoot
