Display assembly
Description Spare part number
39.6-cm (15.6-in) High Definition (HD), LED BrightView display assembly:
●
For use in charcoal grey computer models 639512-001
●
For use in Pacific blue computer models 701769-001
●
For use in black computer models 707798-001
●
LCD rubber kit 640882-001
●
Display hinges 639511-001
●
Display hinge covers 640882-001
Before removing the display assembly, remove the following components:
1. Battery (see
Battery on page 30)
2. Service door (see
Service door on page 31)
3. Optical drive (see
Optical drive on page 34)
4. WLAN module (see
WLAN module on page 36)
5. Keyboard (see
Keyboard on page 39)
6. Top cover (see
Top cover on page 41)
7. USB board (see
USB board on page 47)
Remove the display assembly:
1. Turn the computer right-side up, with the front toward you.
2. Open the computer as far as possible.
3. Disconnect the display panel cable (1) from the system board and remove it from its routing
channel.
4. Pull the antenna cables through the opening in the base enclosure (2), and then disengage the
cables from the clip in the routing channel leading to the display hinge.
CAUTION: Support the display assembly when removing the display screws in the following
steps. Failure to support the display assembly can result in damage to the assembly and other
components.
5. Remove the five Phillips 6.0 x 2.5 screws (3) that secure the display assembly to the computer.
50 Chapter 4 Removal and replacement procedures
