A SERVICE OF

logo

Commands62
Temperature log page
The Temperature Log page is page 0Dh. The following parameters are supported:
DTD Status log page
The Data Transfer Device (DTD) Status Log page is page 11h. The following parameters are
supported:
Parm. Description
0h The current temperature of the drive in ºC (binary value). If the temperature is less than 0, 0 is
reported. If the temperature sensor is not functioning properly, FFh is reported.
1h The maximum temperature in ºC (binary value) at which the drive can operate continuously
without degrading reliability and operation. This parameter is not supported so FFh is returned.
7 6 5 4 3 2 1 0
0 Page Code (0Dh)
1 Reserved (0)
2 (MSB)
Page Length (0Ch)
3 (LSB)
4 (MSB)
Parameter Code (0000h)
5 (LSB)
6 DU (0) DS (1) TSD (0) ETC (0) TMC (0) LBIN (1) LP (1)
7 Parameter Length (2h)
8 Reserved (0)
9 Temperature (ºC)
10 (MSB)
Parameter Code (0001h)
11 (LSB)
12 DU (0) DS (1) TSD (0) ETC (0) TMC (0) LBIN (1) LP (1)
13 Parameter Length (2h)
14 Reserved (0)
15 Reference Temperature (ºC)
Parm. Description
0000h Very High Frequency data
0001h Very High Frequency polling delay
0100h–01FFh DTD Primary Port status