HP OmniBook XE3 Removal and Replacement 2-19
Installing a New Display Assembly
When installing a new display, you must make sure to set the DIP switches on the video PCA to match
the particular display assembly. Do this as follows.
Caution
Setting the DIP switches improperly could damage the display assembly.
1. Find the manufacturer of the display: this is shown on a label attached to the display assembly.
2. Find the display’s manufacturer and model in the table below, and set the DIP switches on the
video PCA as shown.
Model 1 2 3 4
CPT 14.1-in TFT XGA ON OFF ON OFF
Hitachi 15.0-in TFT XGA OFF ON OFF OFF
LG 13.3-in TFT XGA ON OFF OFF ON
LG 14.1-in TFT XGA OFF ON OFF ON
LG 15.0-in TFT XGA ON ON ON OFF
Mitsubishi 12.1-in TFT SVGA ON OFF ON ON
Samsung 12.1-in TFT SVGA ON ON OFF OFF
Samsung 14.1-in TFT XGA OFF ON ON OFF
Sanyo 12.1-in TFT SVGA OFF OFF ON ON
Unipac 13.3-in TFT XGA OFF OFF ON OFF
Unipac 14.1-in TFT XGA OFF OFF OFF ON
As an example, the following figure shows the DIP switches set to OFF-ON-ON-ON:
Figure 2-13. Video PCA DIP Switches
2134
F
O
F
