3.13 Other Modes
3-66
4
44
4
Press the U or V key repeatedly until > Service
> appears.
5
55
5
Press the Z key.
6
66
6
Press the U or V key repeatedly until >> Color
Calibration appears.
7
77
7
To let the printer perform color calibration, press the
ENTER key. A question mark ( ? ) appears to let you
confirm the execution of calibration.
8
88
8
Press the ENTER key. The message display shows
Please wait (Calibrating) and calibration
will start.
9
99
9
When calibration is finished, the display returns to
Ready.
3.13.16 Using High Density Mode
When the high density data such as solid color or a page
including many images is continuously printed, the printing
density may lower. In such a case, you can prevent the
printing density by changing the mode setting to the High
Density Mode. However, if you perform the continuous
printing in this high density mode, the printing speed will be
reduced.
Caution
When the RAM disc of the printer is set to
effective or a hard disc is attached to the
printer, set the RAM disc or the hard disc to ON
in the device setting menu of the printer driver.
Otherwise, the high density mode will become
invalid.
1
11
1
Press the MENU key.
2
22
2
Press the U or V key repeatedly until Others >
appears.
3
33
3
Press the Z key.
4
44
4
Press the U or V key repeatedly until > Service >
appears.
5
55
5
Press the Z key.
>Service >
>>Color
Calibration
>>Color
Calibration ?
Please wait
(Calibration)
01
Standard (Initial setting)
02
Printing speed has a priority. Secure the appropri-
ate printing density by controlling the reduction
of the printing speed.
If the density is a little discolored in the standard
printing mode, use this mode.
03
Printing density has a priority. The printing den-
sity takes priority in printing operation so that the
printing speed becomes slower than when 02 is
selected.
Others >
>Service >
