You can find these WPS logos on the side, back, or top of your access point.
For more information on accessing the wireless settings and determining the WPS capability of your access
point, see the documentation that came with the access point or contact your system support person.
Configuring Wi‑Fi Protected Setup manually
Note: Make sure your access point (wireless router) is Wi‑Fi Protected Setup (WPS) certified. For more
information, see the User’s Guide.
If your printer or device has not yet been configured for wireless connection and you want to configure
it using WPS, then push the WPS button on the wireless router. Wait for the printer control panel to display
a message to begin WPS configuration. There might be a short delay before the message appears. If nothing
happens after 30 seconds, then do one of the following:
USE THE PUSH BUTTON CONFIGURATION (PBC) METHOD
1
From the printer control panel, navigate to:
> Setup >
OK
> Network Setup >
OK
> Wireless 802.11b/g/n >
OK
> Network Connection
Setup >
OK
> Wireless >
OK
> Wi‑Fi Protected Setup >
OK
> WPS PBC Mode >
OK
2 Follow the instructions on the printer display.
USE THE PERSONAL IDENTIFICATION NUMBER (PIN) METHOD
1
From the printer control panel, navigate to:
> Setup >
OK
> Network Setup >
OK
> Wireless 802.11b/g/n >
OK
> Network Connection
Setup >
OK
> Wireless >
OK
> Wi‑Fi Protected Setup >
OK
> WPS PIN Mode >
OK
2 Follow the instructions on the printer display.
Wireless networking 42
