How to Operate
- 13 -
NE-1037
Programming
DO NOT OPEN THE DOOR
The display window MUST be blank before programming. If any indicator light is illuminated in the digital
display window: close the door, press the Stop/Reset Pad and wait 1 minute until the display goes blank.
Example: To program 30 seconds at 500 W for Memory Pad 5
A. Programming Memory Pads for Single Stage Heating:
NOTE: • Program the remaining Memory Pads as desired by repeating steps 1 - 5. You may insert up to 10
memory programs.
• When the Program indicator “ ” is blinking, the program can be cancelled and/or the pad number
erased by pressing the Stop/Reset Pad.
1.
2.
3.
4.
• Press the Program Pad.
Note:
• If no “ ” Indicator appeared on
display, “Program Lock” should be
cancelled. (See page 16)
• Press the Memory Pad 5. The pad
number and the previously selected time
and power level will appear in the display.
• The pad number and Stage Heating
Indicator will appear in the display again.
• Press the Power Level Pad twice. The
Memory Pad number will go out.
• Press Memory Pads 3 and 0.
5.
• Press the Program Pad again.You have
completed programming the selected
Memory Pad for single stage heating.
Double heating time for double quantity
heating was automatically set.
• 2 seconds later, the time and power level
setting you programmed will appear in
the display.
• 2 seconds later, Double Quantity Heating
Indicator and then the double heating
time will appear in the display.
• 2 seconds later, the display will go blank.
The Memory Pad 5 is now programmed for
heating - 30 seconds at 500 W.
