For appliances without soft stop mechanism adjust door
stop cushioning.
The door stop cushioning can be
adjusted if necessary using the
accompanying Allen key 5:
u
For stronger spring force: turn
clockwise.
u
For lesser spring force (as-deliv-
ered): turn anticlockwise.
Check the following points to ensure the appliance is fitted
properly. Failure to do so may lead to icing, condensate
forming and malfunction:
w
The door has to close properly
w
The unit door must not butt against the unit body
w
The seal must have a firm fit at the upper corner on the
handle side. To check, darken the room, place a torch inside
the appliance at the top and close the door. If light shines
through, check the installation.
2.4 Connecting the appliance
NOTICE
Risk of damage to the electronic control system!
u
Do not use stand-alone inverters (conversion of d.c. to a.c./
three-phase) or energy saving plugs.
WARNING
Fire and overheating hazard!
u
Do not use extension cables or multiple socket outlets.
The type of current (alternating current) and voltage at the
installation site have to conform with the data on the type plate
(see Appliance at a glance).
Connect the appliance only with a properly installed
socket outlet with earthing contact. The socket outlet
must be fused with 10 A or higher.
It must be easily accessible so that the appliance can
be quickly disconnected from the supply in an emer-
gency. It must be outside the area of the rear of the
appliance.
u
Check the electrical connection.
u
Plug in the power plug.
Putting into operation
8
