A-5
INSTALLATION
POWER WAVE® S350
A-5
CONNECTION DIAGRAMS
GTAW (TIG) WELDING
A user interface is required for adjusting the TIG weld-
ing settings. S-series user interface (K3001-1) can be
installed into the power source (Figure A.3). Refer to
the connection diagrams based on the user interface
that is being used. Alternate configurations are possi-
ble depending on the wire feeder that is being used.
Refer to the wire feederʼs manual for alternative config-
urations.
SMAW (STICK) WELDING
Similar to TIG welding a user interface is required for
adjusting the Stick welding settings. A Power Feed
wire feeder can be used as the user interface, or a
K3001-1 (user interface control panel) can be installed
into the power source (Figure A.4). The connection
diagram shown is based on the S-Series user inter-
face (K3001-1). In this diagram the remote control box
is optional.
GMAW (MIG) WELDING
An arclink compatible wire feeder is recommended for
Mig welding. Refer to Figure A.5 for the connection
details.
