LOW VOLTAGE CIRCUIT TEST (continued)
PROCEDURE
1. Remove input power to the Pro-Cut 55
machine.
2. Using the 5/16" nutdriver remove the case
wraparound cover.
ELECTRIC SHOCK can kill.
• Do not touch electrically hot parts.
3. Apply the correct input power to the machine
and carefully check for the following voltages.
4. Check for the presence of approximately 28
VDC on the output board.
a. LED1 should be lit when 28 VDC is present.
See Figure F.13. See Output Board LED
Definitions and Figure F.12, Low Voltage
Circuit Diagram.
b. To verify the presence of 28 VDC, check
across capacitor C13. Make certain the
voltmeter probes make good contact with
the capacitor leads. See Figure F.13.
5. Check for the presence of 17 VDC on the out-
put board.
a. LED2 should be lit when 17 VDC is present.
See Figure F.13. See Output Board LED
Definitions and Figure F.12, Low Voltage
Circuit Diagram.
b. To verify the presence of 17 VDC, check
from plug J31 Pin-6 to diode D25 (anode).
See Figure F.13. Make certain the volt-
meter probes make good contact with pin-
6 and the diode anode lead.
6. Check for the presence of +15 VDC on the
control board.
a. LED1 should be lit when +15 VDC is pre-
sent. See Figure F.13. See Control
Board LED Definitions and Figure F.12,
Low Voltage Circuit Diagram.
7. Check for the presence of -15 VDC on the con-
trol board.
a. LED3 should be lit when -15 VDC is pre-
sent. See Figure F.13. See Control
Board LED Definitions and Figure F.12,
Low Voltage Circuit Diagram.
WARNING
