18 19
KEY TO THE MAIN COMPONENTS OF
THE APPLIANCE
1. Adapter with cord
2. Charger jack
3. Comb
4. Scissors
5. Holder
6. Lubricating oil
7. Cleaning brush
8. Cutting head
9. Locking ring
10. On/Off button
11. Recharging indicator
12. Charger jack
13. Large comb, 4, 7, 10, 12 and 16 mm
14. Fine comb, 1 and 3 mm
PRIOR TO FIRST USE
Before using for the rst time, fully charge
the battery (See Battery Charging below),
which takes approx. 8-12 hours.
USING THE APPLIANCE
The appliance is designed for cutting and
trimming of hair and beard and can be
used with or without a comb attachment,
depending on the required length.
Fitting the comb attachment
• Fit the required comb attachment (13
or 14):
o Set the locking ring (9) so the
unlocked symbol is level with the
arrow on the appliance.
o Place the desired comb attachment
over the cutting head (8) so the
small pins on either side of the
cutting head click into place in the
small indentations on either side of
the comb attachment.
o Remove the comb attachment by
carefully pulling it away. The locking
ring must be unlocked.
• Set the comb attachment to the
desired cutting length by sliding it
up and down the appliance until the
arrow on the appliance is level with the
desired length.
o The small comb attachment can
be set to lengths of 1 or 3 mm and
the large comb attachment can be
set at 4, 7, 10, 12, 14 or 16 mm.
• Lock the locking ring by turning it until
the locking symbol is level with the
arrow on the appliance.
• Switch on the appliance using the
on/off button (10) and commence
trimming.
Trimming and shaving without a comb
attachment
The cutting head is used to trim the beard
and shave the head, e.g. in the neck.
Carefully slide the appliance over the skin
with slow even movements at a low angle
and without using pressure.
• Take care not to push in the direction of
the cutting head or to push the cutting
head sideways.
• Caution! The cutting head is very
sharp, so be careful!
Trimming with a comb attachment
Trim the beard by using the appliance with
a decreasing cutting length until the beard
has the desired length.
Symbols on locking ring
Unlocked symbol
Locked symbol
Thinning symbol
