Operating the Pump Motor in the RUNNING Display Mode
6
6-17
6.4.1 Pumping in the TOTAL VOLUME Mode
To pump fluid in the TOTAL VOLUME Mode, do the following:
1. Set up the pump motor for pumping, according to Chapter 3.
2. Toggle the ON/OFF switch to turn on the unit’s power. The display is in the
STOPPED Display Mode. Refer to Figure 6-7.
3. Using the procedure outlined in Sections 6.1.1. and 6.2.1, adjust either the
RPM or FLOW RATE setting.
4. When the display flashes the RPM or FLOW RATE setting you desire, press the
TOTAL VOLUME key.
The display flashes the current TOTAL VOLUME setting (xxx mL or xxx Liters).
5. Use the UP and DOWN ARROW keys to enter the TOTAL VOLUME setting you
desire. Refer to Figure 6-8 for the TOTAL VOLUME range.
Figure 6-8. TOTAL VOLUME Range
