Paper Jams
18
4
Install the thermal transfer film.
• Refer to steps 3 and 4 in the section of “Installing the
Thermal Transfer Film” on pages 10, 11.
• “ ” flashing on the Multi-Copy/Error Indicator will go
out.
• If “ ” is still flashing after closing the printer door,
make sure that the thermal transfer film has been
installed properly and tightened.
• The printer door should be closed to make copies
properly. Confirm both latches are locked.
If the flashing “” does not go out after the foregoing procedure has been performed; this may indicate that the
paper feeder is not functioning properly.
Reload the copy paper by following the steps given below.
1
Turn the power off.
2
Open the paper cover and remove all the copy
paper remaining inside the unit’s paper cover.
• The copy paper will slightly resist being removed, but
may be pulled out without problems.
Notes
ON
OFF
Note
