22 Customer Care Center 1-800-732-2677
To Cross Hard Surfaces
(driveways, sidewalks, etc.)
WARNING
Follow all safety instructions for your power tools. Be sure to
always wear your safety goggles.
Concrete Driveway or •
Sidewalk (7C): Place
the Boundary Wire in a
convenient expansion
joint or create a groove
using a circular saw and
masonry blade. Place the
Boundary Wire in the
groove and cover with an
appropriate waterproofi ng
compound. For best
results, brush away dirt
or other debris before
patching.
7C
7D
Gravel or Dirt Driveway (7D):• Place the Boundary Wire in a PVC pipe or
water hose to protect the Boundary Wire before burying.
Place the Boundary Flags
The Boundary Flags are visual reminders for your pet of where the Warning Zone
is located.
Place the Test Light 1.
contacts on the
contact points and
hold the Receiver
Collar at your pet’s
neck height.
Walk towards the 2.
Warning Zone until
the Receiver Collar
beeps (8A).
Place a Boundary Flag 3.
in the ground (8B).
Walk back into the4.
Boundary
Wire
8A
8B
Pet Area until the beeping stops.
Repeat this process around the Warning Zone until it is marked with Boundary 5.
Flags every 10 feet.
Note: If you cannot hear the beep, see the Test Light Instructions in Step 6.
CAUTION
To prevent an unintended corection, after the Boundary Flags have
been placed, be sure to set the static correction on the Receiver
Collar back to level 1 Tone Only.
Step
8
