How to reset the lter capacity
Note: Always reset the lter capacity when you replace the lter cartridge.
This is necessary to set the remaining lter capacity back to its initial value
(i.e. 2500, 1500 or 900 litres).
1 Press the reset button for 2 seconds
2 Press the lter capacity selection button.
The set lter capacity ashes on the display for 4 seconds.
3 If the new lter cartridge has the same capacity as the old
cartridge, simply wait until the setting stops ashing.
4 If the new lter has a different capacity, press the lter capacity
selection button again until the display shows the capacity of your
lter cartridge (1500-2500-900-1500 etc.).
5 Stop pressing the lter capacity selection button when the display
shows the capacity of the new lter cartridge.
The selected lter capacity and the remaining lter capacity are
shown for 5 seconds.
Replacing the battery
The battery lasts approximately one year in case of normal domestic
use. Replace the battery when the
à symbol lights up and ashes. This
appliance runs on 1 button-type CR2032 (3V) lithium battery, which is
generally available.
1 Remove the water purier from the tap.
2 Wipe the entire water purier with a dry cloth.
3 Place the new battery (see ‘Inserting the battery’ in chapter
‘Preparing for use’).
4 Reattach the water purier to the tap (see the installation
instructions for your adapter type in chapter ‘Preparing for use’).
Note: When you replace the battery, the water purier remembers the
remaining lter capacity. If no battery is inserted in the water purier, the
remaining lter capacity is not counted down.
,
,
ENGLISH 17
