TROUBLESHOOTING
General
Power does not turn
on.
(No sound is
Fuse is blown
Replace with fuse of the same amperage.
If the fuse blows again, consult your store
Consult your local retailer.
No sound output
when operating the
unit with amplifiers
or power antenna
attached.
Power antennal
lead is shorted to
ground excessive
current is required
or remote on the
amplifiers or power
antenna.
2. Remove all wires attached to the
power antenna lead. Check each wire
for a possible short to ground using an
ohm meter.
3. Turn on the unit.
4. Reconnect each amplifier remote wire
to the power antenna lead one by one.
If the amplifiers turn off before all wires
are attached, use an external replay to
provide remote-on voltage (excessive
Nothing happens
pressed.
Display is not
Accurate
The microprocessor
has malfunctioned
due to noise, etc.
Turn off the power, Then press the [no
open] button and remove the DCP. Press
the reset button for about 2 seconds with
a thin rod.
Connectors
Wipe the dirt off with a soft cloth
moistened with cleaning alcohol.
CD
Sound is bad directly
after power is turned
on.
Clean the compact disc without scratches
heavily scratched
Replace with a compact disc without
scratches.
Sound is bad directly
after power is turned
on.
form on the internal
lens when the car is
parked in a humid
Let it dry for about 1 hour with the power
on.
