26 www.pridemobility.com Jet 3 Ultra
V. COMFORT ADJUSTMENTS
Elevating Leg Rests (Optional)
Elevating Leg Rests (ELRs) offer an infinite range of adjustment
for the leg angle and a footrest adjustment range of 12–19 in.
To rotate the ELRs:
1. Push in release lever A. See figure 20.
2. Rotate the ELRs.
To adjust the ELR angle:
1. Push down release lever B. See figure 20.
2. Move the leg rest to the desired angle.
To adjust the ELR length:
1. Remove the two adjustment screws from the side of each leg
rest extension. See figure 20.
2. Slide the leg rest up or down to the desired length.
3. Reinstall the two adjustment screws.
Anti-Tip Wheels
The anti-tip wheels are designed to give your power chair increased
stability on rough surfaces. The anti-tip wheels are preset at the
factory for smooth surfaces or indoor use only. If you plan on
using your power chair on rough surfaces, it may be necessary to
adjust the anti-tip wheels to better suit your needs. The anti-tip
wheels may need adjustment if the following occurs:
! When coming to a stop, your power chair tips forward
excessively.
Figure 20. Elevating Leg Rests
! The anti-tip wheels constantly rub the ground.
WARNING! Consult your authorized Pride Provider
before attempting to change the anti-tip wheel
height! Changing the anti-tip wheel height affects
handling under acceleration!
WARNING! The higher you raise the anti-tip wheels, the more you increase your power chair’s
tendency to tilt forward while decelerating. You can compensate for this by having your authorized
Pride Provider make a small adjustment to the pre-programmed deceleration setting in the
controller or by moving the seat assembly farther to the back of your power chair.
PROHIBITED! Do not remove the anti-tip wheels.
NOTE: Each drive tire must be inflated to 35 psi (if equipped with pneumatic tires) and the user must also
be seated in the power chair in order to properly adjust the anti-tip wheels.
To adjust the anti-tip wheels:
1. Loosen bolt A. See figure 21.
2. Remove bolt B.
3. Raise or lower the anti-tip wheel. Each hole is 1/2-in. apart.
4. Reinstall bolt B.
5. Tighten bolt A.
6. Raise or lower the other anti-tip wheel so that it is at the same height.
ANTI-TIP WHEEL
A
B
ADJUSTMENT SCREWS
RELEASE LEVER B
RELEASE LEVER A
LEG REST
EXTENSION
Figure 21. Anti-Tip Wheel Assembly
