13. After completing the setup program for one of the radios, perform steps 7-13 for
the other radio, making sure that the Operation Mode selection is set to the
opposite mode of the other radio.
After configuring both radios, exit from the HyperTerminal program by closing the
window or using the Exit selection in the File dropdown menu.
Select Yes to disconnect from the current session of HyperTerminal.
Yagi Antenna Installation
Prior to the installation of the radios and the antennas, disconnect the power to the MIM or
MDI to prevent communication until the installation is complete. It is highly desirable to
obtain a line of sight when mounting the Yagi directional antennas to increase the strength
and reliability of the communication signal.
PolyPhaser Installation
A PolyPhaser surge protector must be installed at each radio location to provide in-line
protection against lightning. Each of the PolyPhaser surge protectors must be grounded
using a dedicated external grounding rod.
