Manual-4
INTERNAL ADJUSTMENTS
ere are a number of controls inside the CP 64S used to config-
ure the system for specific applications. Access to these controls
is only required once before initial system setup. Do this before
the CP 64S is installed in a rack or wired into a system. Make
sure the power cable is unplugged before removing the top cover
to gain access. Refer to the diagram below for control locations.
ere are five internal switches related to the two Page Inputs.
e dot on the circuit board shows the factory default:
1 Page 1 Phantom Power 15VDC Default: OFF
2 Page 2 Phantom Power 15VDC Default: OFF
3 Page Priority P1, NO, P2 Default: P1
4 Zone 1 Page Sum Pre- or Post-VCA Default: Pre-VCA
5 Zone 2 Page Sum Pre- or Post-VCA Default: Pre-VCA
1 2 Phantom Power is available for both Page Inputs. If
phantom power is required for the intended microphone, then
set the appropriate switch to ON. If a Paging Input Mic / Line pad
switch is set to LINE, Phantom Power is automatically defeated.
3 Page Priority Assign allows you to select one of the Page
Inputs as a Priority Page Input. e Priority Pager overrides the
non-priority Pager in the Zone(s) it is assigned. Note that the
non-priority Pager may still broadcast in any Zone that the Pri-
ority Pager is not assigned to or not currently broadcasting in. Set
the switch to P1 if you wish Page 1 to have priority over Page 2.
If you wish Page 2 to have priority over Page 1, set the switch to
P2. If NO is selected, neither Paging Input has priority and both
Pagers may be active at the same time. is allows the Paging
Inputs to mix for applications like karaoke or PA. If a Page Input
is used for emergency paging, set it as the Priority Pager.
