10
5. Re-Fit the front cover (see diagram 9)
a. Ensure outer knob “A” is aligned fully anti-clockwise to the “ (stop)“ position.
b. Ensure inner knob “B” is aligned to the “ (high)” position.
c. In the main body of the shower, turn the “Drive Spider” fully anti-clockwise until it stops.
d. In the main body of the shower, turn the “Drive Gite” anti-clockwise until it is at “12 o’clock”.
e. Fit the front cover of the shower to the main body ensuring that the 3 x “Drive Spider Legs”
engage with the slots in outer knob “A”.
f. Check that outer knob “A” has been correctly aligned by ensuring that all 3 power settings can
be selected, and returns to the “ (stop)“ position.
g. Check that inner knob “B” has been correctly aligned by turning clockwise and ensuring that
knob turns approximately 3/4 of a turn (270°) and when turned back fully anti-clockwise,
returns to the “ (high)” position.
6. Replace the top and bottom fastening screws.
7. Fit the shower hose, and operate the shower first without the handset to flush out particles,
fit the handset and then operate the shower as on page 3 or 12 and check:
a. That the water gets to a satisfactory temperature.
b. Water flow can be adjusted by inner control knob “B”.
c. Power selection operates in all 3 positions, giving a change in water temperature and
that the neon light functions correctly.
d. Check again for leaks
e. That the holes in the shower handset are not blocked
