M30870T-EPB User’s Manual 3. Usage (Emulator Debugger)
REJ10J0482-0300 Rev.3.00 February 16, 2006
3. Specifying a trace range
Specifying a trace range
4. Setting the trace write condition
You can specify a trace range for the trace event.
- Break
256K cycles of instruction execution before the use
program stopped is recorded.
- Before
256K cycles of instruction execution before a trace poin
condition was met is recorded.
- About
128K cycles of instruction execution before and after a
trace point condition was met is recorded.
- After
256K cycles of instruction execution after a trace poin
condition was met is recorded.
- Full
256K cycles of instruction execution after a trace began is
recorded.
Setting the trace write condition
You can specify a condition for the cycles to be written into
the trace memory.
- Total
All cycles are written into memory.
- Pick up
Only the cycles in which the specified condition was me
are written into memory.
- Exclude
Only the cycles in which the specified condition was no
met are written into memory.
When you have finished setting the trace write condition,
click this button. The Realtime-trace Write Condition dialog
box shown below will appear.
Write mode
Only the cycle in which the specified Start event occurred
A range of cycles from when the specified Start even
occurred to when the specified Start event became
nonexistent
A range of cycles from when the specified Start even
occurred to when the specified End event occurred
Page 75 of 104
