Section 7: Replacement Procedures
SATO M10e Service Manual PN 9001113A Page 7-21
5 Lift away cover (2) and disconnect sensor harness (A) from sensor connector (A).
6 Connect sensor harness (A) to sensor connector (A) of replacement sensor (4).
7 Secure cover (2) and sensor (4) to left guide plate (3) using screw (1).
Figure 7-16, Label Gap Sensor Replacement
EYE MARK SENSOR
The eye mark sensor is accessed from underneath the ramp. Great dexterity is required to
replace the eye-mark sensor without removing the printer frame. Patiently attempt replacement
without removing the frame. If unsuccessful, remove the frame as directed in the Power Board
Replacement procedure of this section. Refer to Figure 10-4 of the Diagrams & Schematics
section for sensor location guidance.
1 Switch off the printer and disconnect the power supply cord.
2 Remove the top, front, left, and right housing covers.
NOTE: A properly installed sensor will be oriented with its eyes downward
and its mounting orifice align with those of the cover and left guide plate.
NOTE: Figures 10-1 and 10-2 of the Diagrams & Schematics section
provides guidance on housing cover and media removal.
4,
A
1
A
3
2
2
