- i =
L¸ J JL i
FULL ONE YEAR WARRANTY ON CRAFTSMAN COPY-CRAFTER
CENTER/DEPARTMENT THROUGHOUT THE UNITED STATES.
This warranty gives you specific legal rights, and you may also have other rights wh ch vary from state to state.
SEARS, ROEBUCK AND CO., Dept. 698/731A, Sears Tower, Chicago, IL 60684
i
Before operating the Copy-Crafter read and understand your Lathe and Copy-Crafter
owner's manuals and affixed warnings.
The General Safety Instructions which follow appJy to your Lathe and Copy-Crafter in
combination as a "power tool."
general safety instructions
1. KNOW YOUR POWER TOOL 10.
Read the owner's manual(s) carefully, Learn
its application and limitations as well as the
specific potential hazards peculiar to this
11.
tool:
2. GROUND ALL TOOLS
This tool is equipped with an approved 3_
co nductor cord and a 3-prong grounding type
plug to fit the proper grounding type recep-
tacle. The green conductor in the cord is the
grounding wire. Never connect the green 12.
wire to a live terminal:
3. KEEP GUARDS IN PLACE
in working order, and in proper adjustment
and alignment.
4. REMOVE ADJUSTING KEYS AND
WRENCHES 13.
Form habit of checking to see that keys anO
adjusting wrenches are removed from too!
before turning it ON. !4.
5. KEEP WORK AREA CLEAN
Cluttered areas, floors and benches invite
accidents. Floor must not be slippery due to
15.
wax or sawdust.
6. AVOID DANGEROUS ENVIRONMENT
Don't use power tools in damp or wet loca-
tions or expose them to rain. Keep work area
16.
well lighted. Provide adequate surrounding
work space.
7. KEEP CHILDREN AWAY
AIJ visitors should be kept a safe distance
from work area.
8. MAKE WORKSHOP KID.PROOF
with padlocks, master switches, or by
removing starter keys.
9, DON'T FORCETOOL
It will do the job better and safer at the rate
for which it was designed.
USE RIGHT TOOL
Don't force tool or attachment to do a job it
was not designed for.
WEAR PROPER APPAREL
Do not wear loose clothing, gloves, neckties
or jewelry (rings, wrist watches) to get caught
in moving parts. Nonslip footwear =srecom-
mended. Wear protective hair covering to
contain long hair. Roll long sleeves above the
elbow.
USE SAFETY GOGGLES (Head Protection)
Wear Safety goggles (must comply with
ANSIZ87.1) at all times. Also, use face
or dust mask it cutting operation is dusty,
and ear protectors (plugs or muffs) during
extended periods of operation.
SECU RETOOL FIXTU RES
Support cutti'ng tool with tool rest or tool
post.
DON'T OVERREACH
Keep proper footing and balance at a!l
times.
MAINTAIN TOOLS WITH CARE
Keep tools sharp and clean for best and
safest performance. Follow instructions
for lubricating and changing accessories.
DISCONNECT TOOLS
before servicing, and when changing
accessories.
17. AVOID ACCIDENTAL STARTING
Make sure switch is in "OFF" position
before plugging n. f a power failure occurs
while operating, turn switch "OFF" and
remove switch key.
18. USE RECOMMENDEDACCESSORIES
Consult the owner's manual for recom-
mended accessones. Follow the instructions
that accompany the accessories. The use of
improper accessories may cause hazards.
