GETTING TO KNOW YOUR SAW
_1 SAWSLADE
TABLEINSERT
MITER GAUGE |0 EXACT-I-CUT
\
LOCK HANDLE
6 MITER GAUGE
7" BLADE GUARD
ANTIKICKBACK
PAWLS
RiP FENCE
RIP FENCE
LOCK HANDLE
4 TILTLOCK HANDLE
(UNDERNEATH TABLE)
2 ELEVATION HANDWHEEL
\
1 ON-OFF SWITCH
1 ON-OFF SWITCH
CAUTION: Before turning switch on, make sure the blade
guard is correctly installed and operating properly.
The On-Off Switch has a locking feature. THIS FEATURE
IS INTENDED TO PREVENT UNAUTHORIZED AND
POSSIBLE HAZARDOUS USE BY CHILDREN AND
OTHERS_
B. TO turn saw ON ... stand to either side of the
blade never in line with it ... insert finger under
switch leverand pull END of lever out.
After turning switc_hON, always allow the blade to
come up to full speed before cutting.
Do not cycle the motor switch on and off rapidly,
as this may cause the sawblade to loosen. !n the
event this should ever occur, allow the sawblade to
come to a complete stop and retighten the arbor
nut normally, not excessively, Never leave the saw
while the power is "'ON".
C. TO turn saw OFF ... PUSH lever in. Never leave
the saw until the cutting tool has come to a
complete stop.
D. TO lock switch in OFF position ... hold switch IN
with one hand ... REMOVE key wi_ other hand.
WARNING: FOR YOUR OWN SAFETY, LOWER
BLADE OR OTHER CUTTING TOOL BELOW
TABLE SURFACE. (IF BLADE IS TILTED,
RETURN IT TO VERTICAL (90 °) POSITION).
ALWAYS LOCK THE SWITCH "OFF", WHEN
SAW IS NOT IN USE ... REMOVE KEY AND
KEEP IT IN ASAFE PLACE ... ALSO ,.. IN
THE EVENT OF A POWER FAILURE (ALL OF
YOUR LIGHTS GO OUT) TURN SWITCH OFF
... LOCK IT AND REMOVE THE KEY. THIS
WILL PREVENT THE SAW FROM STARTING UP
AGAIN WHEN THE POWER COMES BACK ON,
@
KEY
(YELLOWPLASTIC)
2O
