PICKING UP BOBBIN READ
1. Raise pr_ foot lever. Hold n_ie
threed I_y in left hand and rotate
he,heel toward you _ complete
turn. (Fig. 1)
2. Bring bobbin thread up by pulling upper
thread. (Fig. 2) ®
3. Pull both threads under and to the back
of the presser foot, leaving 3 to 4 inches
of thread clear, (Fig, 3)
/
®
FIg.2
If you can no1: pick up bottom thread by
following chore steps, then check:
1, is needle threaded ?
2, Is thread tangled around needle ?
3, Is bobbin case threaded correctly with
thread going through slots A and Ber
shown on page 11, Fig. 4 end 5 ?
4, Is there 4 inches of thread coming from
bobbin case and through slot of needle
plate as shown on _ge 11, Fig. 6?
5. Is thread from bobbin case tangled ?
Fig. 3
13
