Using Your TV and Remote
With VCR: Setting the VCR1 Channel
The VCR 1 Channel works with VCR1 on the remote. If the VCR 1 Channel
is set, pressing VCR1 selects the channel to see the VCR picture. The
VCR 1 Channel setting depends on which diagram you have used from the
Connection Guide. If you want to turn this feature off, set the VCR 1
Channel to Disable. Refer to the chart below for your setting.
1. Select the Setup Menu
13
Controls Alarm Adiust Setu .....
CablelAir: Cable
A. Press TV to set the remote to
control the TV.
B. Press MENU to select the Setup
menu. This menu is white.
2. Highlight VCR1 Channel
131
Controls Alarm Adjust Setup
:.:_AutoProgram
Labe[!i 13 ; clear
:Channel Memory: 13 Stored
Cable/Air: Cable
A. Press CHANNEL down to
highlight the VCR 1 Channel.
B. Press + to highlight the channel.
3. Enter channel number
4. Press DONE to save the
setting
3.3
Controls Alarm Adjust Setup
Autoprogram
Label 13 clear
Channel Memory: 13 Stored
Cable/Air: Cable
A. Enter channel 00, 03, or 04.
Choose your setting from the
chart below. Press + if you want
to turn this feature off (Disable).
B. Press DONE to save the setting.
Diagram used from the
Connection Guide:
1B, 1C, 2B, 2C, 3B, 3C, 4C, 5C
4B, 5B
Set VCR1 Channel to:
00
3 or 4 (same as 3/4 switch)
