NON-THROUGH CUTS
See Figure 50.
,_, WARNING: Unplug the saw while removing or
replacing the blade guard, Turn on the saw with
the switch on the arm to confirm the blade is not
receiving power.
• Remove the blade and blade guard (see Assembly
section),
• Place a support the same height as the saw table
nearby for the cut work. Lower the blade with the
elevating handwheel,
• Make sure the wood is not touching the blade.
Insert the key and turn on the saw, Let the blade
build up to full speed before contacting the work-
piece,
,_ WARNING: Always use pushblocks when
making non-through rip cuts to avoid the risk of
serious injury. Never feed wood with your hands.
• When the work is completed, press the switch off
and remove the key,
NON-THROUGHCUT
Fig. 50
CRRFTSMRN_RADIALSAW 315.220100 54
