26
26
Mounting the antennas to the front of the Quadpack
If your Quadpacks are to be mounted into a rack or a tower, the antennas
can be connected to the front side by using the GA 3030 AM antenna mount
(see „Accessories” on page 31).
̈ Mount the antenna holders ¿ to the two outer handles of the two Quad-
packs as shown in the diagram on the left. Fasten the antenna holders by
means of the supplied four screws and plain washers to the prepared
holes.
̈ Guide the two cables sideways to the rear of the Quadpacks.
If you wish to mount the two Quadpacks into a rack, fix the two
cables » of the GA 3030 AM antenna mount to the rack mount
“ears” · as shown in the diagram on the left.
̈ Connect the two telescopic antennas to the antenna holders ¿ and align
the antennas upwards.
Daisy-chaining two Quadpacks
If you daisy-chain two Quadpacks and mount them side by side into a rack,
they can be operated with only one pair of antennas. This pair of antennas
can be connected to the front of the rack as described above.
̈ Connect one antenna or one cable » of the GA 3030 AM antenna
mount to the BNC socket “ANT. A” ƺ of each Quadpack.
* = to the antennas mounted to the front of the rack.
̈ Connect the BNC socket “RF OUT A” Ƽ of each Quadpack to the BNC
socket “ANT. B” ƻ of the other Quadpack as shown in the diagram
above.
¿» ·
ƻ ƺƻ
ƼƼ
ƺ
# ! "
