Intermediate Frame Snowthrowers
6/2006 3
TP 300-5196-00-IS-SN
Quick Setup List -
Page Setup Procedure Steps to Perform
4 Uncrating
4 Reduce Tire Pressures ❏ Reduce Tire Pressure to 20 psi (137 kPa) & Check
4 Assembly ❏ Install Drift Cutters
5 Assembly ❏ Un-Folding Handles
❏ Connecting Shift Rods
6 Assembly ❏ Spout Rotator
❏ Control Levers
❏ Clean-Out Tool
7 Check Fluid Levels & Fill ❏ Auger Gearcase
❏ Engine Crankcase
❏ Fuel Tank
7 Lubricate Snowthrower ❏ Lubricate all grease & oil points
8 Lubricate Snowthrower ❏ Lubricate the auger Shaft & Assembly
9 Perform Safety Checks
Functional Checks
❏ Check that all Safety Guards are in place.
❏ Check Scraper Bars & Skid Shoe Height
❏ Check Drive Control & Auger Control
❏ Check Chute Direction Control
❏ Check Chute Deflector Control
❏ Check Speed Selector Control
Operational Checks
❏ Start Engine & Test ALL Controls
❏ Test Auger Stopping Time
(Auger MUST stop within
5 seconds after the control is released.)
❏ Test Drive Controls
❏ Check For Fluid Leaks
