Connecting a VCR and Cable TV
Use this hookup if:
• You subscribe to a cable TV system that does not require a cable box.
75-ohm
coaxial cable
(supplied)
Disconnect all power sources before making any connections.
1 Connect the CATV cable to the VCR's IN jack.
2 Using the supplied 75-ohm coaxial cable, connect the VCR's OUT.jack
to the TV's VHF/UHF.jack.
3 Using AUDIO and S VIDEO cables, connect the VCR's AUDIO and S
VIDEO OUT jacks to the TV's AUDIO and S VIDEO IN jacks (VIDEO IN
1 or 3).
75-ohm coaxial 2 LT'_-'_""_
cable (supplied) """"[__
Rear of TV
VCR t
SV EO a e
.-" (not supplied)
S
VIDEO
AUDIO-L
(red)
©
O
o
5
t.Q
Q.
03
g
¢.Q
-4
<
AUDIO cable (not supplied)
Note
,,,When you, cormect. _vide° equipment to both the VIDEO,. and the S VIDEO input jacks, make sure
'Auto YC in the _ (Setup) menu is set to "On' to view the S VIDEO input (see below).
Tips
• You can also use the VIDEO IN 2 jacks located on the fi'ont of the TV to connect your VCR.
• If your VCR is not equipped with S VIDEO, use a VIDEO cable (yellow) instead of the S
VIDEO cable.
When connecting both VIDEO IN and S VIDEO IN
Using the menu, you can select the jack from which the TV receives the input
signal. You can set it for each video input (VIDEO IN 1, VIDEO IN 2 and
VIDEO IN 3) separately. The TV is t;actory set to receive S VIDEO input signals.
1 Press VIDEO 1/2/3 repeatedly until the desired video input appears.
2 Press MENU.
3 Press tt/!l, to select _ (Setup), then press (Z).
4 Press tt/ll, to select "Auto YC," then press @.
5 To watch the pictures input from the S VIDEO input jack:
Press tt/ll, to select "On," then press (_.
To watch the pictures input from the VIDEO input ,jack:
Press 4,/11,to select "Oft," then press CZ).
6 Press MENU to exit the menu screen.
23
