6. Once trampoline assembly is complete, it may be carried to a location near the water
for anchor assembly. This may take several people to lift and carry the product. Do not
attempt to lift this product by yourself. Do not drag across any land surface.
7. To attach the anchor assembly to the trampoline, you need to first turn the trampo-
line over so that the bottom of the unit is accessible. Once turned over, attach the ends
of two of the supplied lengths of rope to opposite underside grommets so that they
extend from one side of the trampoline to the other, crossing in the middle, forming an
‘X’ or ‘+’. Tie one end of the third supplied rope around the intersection of the other two
ropes. Lace the other end of the third rope through the holes in the top of the anchor
bag and tie a knot at the end so the bag does not come off. Once completed, the
anchor bag will hang freely from the bottom of the trampoline as shown in figure 1A.
FIGURE 1A:
8. Utilizing the anchor feature will reduce drifting and unwanted motion of the product.
This product may be anchored by filling the attached anchor sack with sand, rocks, or a
weight of up to 25lbs. Place the anchor on top of the trampoline until product is in the
water at the desired location.
9. The product may be floated or pulled out to the location of your choice where it can
remain for use.
10. If pulled to location, there should be no one on the product until towing has stopped
and the item is anchored. Do not exceed 5 mph when pulling to location.
11. Once the product is in the desired location, drop the anchor bag in the water.
12. Have fun!
MOUNTING PLATFORM CONNECTION:
To connect the mounting platform to the main unit, lace the supplied rope through each
unit and tie a knot at each end as shown on the following page:
BOTTOM VIEW
SIDE VIEW
TRAMPOLINE
GROMMET
CONNECTION
INTERSECTION
ROPE
ANCHOR BAG
PVCTrampolinesManual.qxd 3/5/08 3:47 PM Page 3
